DEMCO PUR 442 UV BİNDER 2K

Description

Solvent-free, polyurethane-based, aliphatic, UV-resistant, hard elastic coating system developed for stone carpet applications.

Advantages

• Solvent-free, 100% solids.
• Creates a seamless, jointless floor.
• Thanks to its hard-elastic structure, it absorbs deformations that may occur in the floor.
• Resistant to UV rays and weathering.
• Resistant to detergents, oils and seawater.

Application Areas

Used as a binder in stone carpet applications made with natural stone aggregates, granular quartz and similar colored stones. By adjusting the amount used, it is a preferred binder for producing water-permeable floors. It is used in a variety of indoor and outdoor applications such as walkways, cycle paths and decorative floors.

Technical Properties

Surface Preparation and Application

Surface preparation:

• Surfaces to be coated must be free of oil, rust, dust and similar contaminants.
• The surface to be coated must be free of moisture, and no loose layer whatsoever may remain.
• Glossy surfaces should be roughened by shot blasting, grinding or scarifying.
• The prepared concrete surface must first be primed with a suitable Demco Solvent-Free Epoxy Primer.
• Any cracks and holes in the surface must be repaired using epoxy putty.

Mixing:

• The entire component B must be poured into the component A container, and the two components must be mixed for at least 3 minutes until a homogeneous mixture is obtained.
• Mixing at low speed is recommended to prevent air bubbles from forming in the mixture.
• The prepared binder mixture is added to the pre-weighed aggregate mix at a rate of 6%-12% and mixed at low speed for about 2-3 minutes.

Application:

• The prepared aggregate-binder mix is poured onto the floor without delay and spread with a trowel or screed bar.
• The application is completed by pressing lightly with a steel trowel to obtain an even surface.

Application Conditions

• Working area temperature must be 15°C – 30°C.
• The ideal substrate temperature for application is 15°C – 30°C.
• The temperature must never fall below 10°C.
• For both outdoor and indoor applications, substrate and ambient temperature as well as ambient humidity must be taken into account.
• Substrate moisture must be below 4% and ambient humidity below 65%.
• It should not be touched or come into contact with water for 24 hours after application.
• During work, mix suitable quantities and continue working until the entire mix has been used up.

Coverage

Approximate consumption for an 8 mm thick stone carpet application:

Storage and Shelf Life

6 months in unopened original packaging, stored at 15 – 25°C in dry, enclosed warehouses away from direct sunlight.

Packaging

Total Net: 20 kg (A: 10 kg / B: 10 kg)

Safety Precautions

Avoid contact of the mixture or its components with skin and eyes; in case of contact, rinse with plenty of water and seek medical advice. Wear protective gloves, clothing and goggles during work, and keep the product out of the reach of children.

Approvals / Standards

Tested to EN 1504-2 within the scope of CE certification.